433MHz Universal Remote Control AC 110V 220V 30A 1CH rf Relay Receiver and Transmitter for Universal Electric appliance Control
RF Output of Good Stability
Wide Availability
Perfect Craft & Detail Control
Excellent Detail Design
- Working vlotage : AC 75~220V
- Max current : 30A
- Maximum power : 2000W
- RF frequency : 433MHz
- Receiving Sensitivity : -105bd
- Amount of storage remote controls : 16 pieces
- Support encoding : 1527 Leaning code
- RF Operating mode : ASK superheterodyne wireless reception
- Receiving range : Open space is more than 50 meters
- Remote operating mode : Momentary Mode /Toggle Mode /Latched Mode
Package include
Receiver module ( include Shell )
Remote Control (include battery )
Wiring Diagram
Momentary Mode:
1. Press and hold one button, relay will turn on;
2. Release the button, this relay will turn off.
Toggle Mode:
1. Press button “A”, relay will turn on;
2. Press button “A” again, this relay will turn off.
Latched mode:
1. Press button “A”, relay will turn on;
2. Press button “B”, this relay will turn off.
Delete the existing data about operating modes
Press the learning button (on the Receiver) 8 times. The existing data will be deleted succeed.
Note:
1. When you receive our products, it may set in one remote mode randomly, that because each product was tested before it can be arranged to shipment. So, please delete the existing data to first use.
2. After deleted the data, all the remote controls cannot work any more.
Set up(Momentary)
1. Press the learning button(on the Receiver) once. Wait for 3 seconds;
2. Press one button on the remote control. Wait for 3 seconds. Succeed.
Set up(Toggle)
1. Press the learning button(on the Receiver) twice. Wait for 3 seconds;
2. Press one button on the remote control. Wait for 3 seconds. Succeed.
Set up(Latched)
1. Press the learning button(on the Receiver) triple. Wait for 3 seconds;
2. Press button “A” on the remote control. Wait for 3 seconds.
3. Press button “B” on the remote control. Wait for 3 seconds. Succeed.
Note:
Delete the existing data before you want to change the operating mode of one remote control.